Great Looking And Heating Pannel Sep 12, 2016

Have been replacing slant fin through out the house for years. In the past used Runtal, this time Biasi. Wish that the American houses be build with the Euro panels in the first place - heat delivery, fuel savings, aesthetics, etc. no comparison. Runtal was a bit easier to install, more obvious as to in/out connections. Biasi has much more options and the instructions are not the best. Once figured this out the plumber had no problem to install. When we do another Biasi it will be a piece of... more

Thank You For Friendly Service Aug 20, 2016

Thank you, good product!

Reznor Udap Series Oct 03, 2016

We purchased 75,000, 120,000, 150,000, and 200,000 BTU units, 28 units in total. The 83% efficient rating helped us offset the cost of the upgrade by being eligible for a rebate from our utility. All heaters were installed and work beautifully. The heaters look great! They are installed in a warehouse with great WIFI access so we controlled all 28 individual heat zones using 28 WIFI thermostats from Honeywell. Couldn't be a happier customer! Now management has control of all 28 heaters with... more

Excellent Equipment Poor Documentation Jul 14, 2016

Would have rated this system 5 stars across the board, but the equipment manuals were poorly written. Equipment: Impressed with the quality of manufacturing, and the quietness of both outdoor and indoor units. Manuals: 1. Outdoor unit manual was acceptable, but lacked some clarity for installation options. 2. Indoor unit manual was terrible. Instructions to open the unit for installation access were incorrect. Lost several hours of time "reverse engineering" the unit to... more

Warmwire Heated Floor Jun 03, 2016

I installed a WarmWire heated floor in a 6'x8' coat room that had no other source of heat. It is on a concrete slab with 2 outside walls and a wall to an unheated attached garage. I glued 2 6mm thick sheets of Cerazorb synthetic cork directly on the concrete. It was super easy to lay the wire on top on the cork using the metal clip system provided. To be safe, I laid a sheet of 1/4" luan plywood on top of the wires while laying the tile. I checked the resistance in the wires at each step... more