Crown Boiler Awr070 - 58k Btu - 83.5% Afue - Hot Water Propane Boiler - Chimney Vent Review Sep 02, 2016

Installed this boiler in June 2012 - Very good documentation - Very good response from customer service when I had a question about the controls. Checked on higher efficiency rated boilers but could not justify the much higher price. Until you make up the increase in price with the savings in fuel the unit would be 8 - 10 years old. By then you would probably have maintenance problems and just check the prices on parts for the higher efficiency boilers (parts prices are very high compared... more

Nice Choice Oct 10, 2016

The radiators went together very easily with the connections provided to the heating pex and there were no leaks. very easy to bleed. they provide much more heat than I was getting from my old wall convectors and seem to retain the heat a long time after the boiler is off. Not hard to hang either as long as you separate the hanger prongs in increments of 1/2 inch. Also, my wife was pleasantly surprised by the appearance

Excellent Radiator. Easy To Install With With The Caleffi Valve. Sep 15, 2016

Easy to install with the caleffi valve and provided brackets. It keeps my daughter's formerly cold ground floor bedroom nice and warm. She no longer needs an electric heater to supplement the old baseboards.

Williamson-thermoflo Gsa-150 - 94k Btu - 82.9% Afue - Steam Gas Boiler - Chimney Vent Review Jul 30, 2016

Built by a division of Weil McLain the boiler it is similar to their products. Seems to be build well and I hope to have years of trouble free working status. A little difficult to install given the position of the ports. I will recommend this product to others.

Energy Efficient, High Quality Product Sep 15, 2016

I installed this unit about a month ago to heat/cool our 3rd floor loft (finished attic) and it has been working flawlessly so far. It is energy efficient and was straightforward to install using the instructions provided and the appropriate tools (torque wrench, vacuum pump in addition to standard tools). I did purchase a genuine Mitsubishi lineset (MLS143812T-15) elsewhere and found that the torque value of 25-30 ft-lb specified for the 3/8" flare connection was too much and it... more