Nice Panel Radiator Sep 04, 2016

I just wish it was more simple to figure out which connectors were needed. The description should be simpler. All I wanted was 1/2" copper connections but somehow the unit showed up with PEX connections. Overall good radiator though.

Fgc 6xl, 483 Cfm Sep 10, 2016

One fan, and A coil is not freezing up has run from 6 am till now -- 7:30pm at 93 degrees outside temp---- other two should be coming to their new home soon

Owner, Custom Made Jul 13, 2016

I replaced a Dunkirk XEB-3 (20 yrs. old) with the Dunkirk boiler above. The new one is all most identical to the old one, that is the pipes were located same as the old, so gas and water lines were easily plumbed. The old electrical wires could be used although lengthened to connect to the digital controls. The circulators location has changed, it's still provided with its wiring provided. Venting is the same as the old one. I was happy to get another Dunkirk that installed easily.

Fabulous Design Feb 16, 2016

Very simple and sleek design. Does a great job of heating my 350 sq ft office.

Great Heater! Sep 29, 2016

This little heater does a wonderful job of keeping my two car garage nice and warm all winter long. I use my garage for a man-cave workshop in addition to parking my vehicles. I purchased this one because 15 years ago I purchased an ADP similar model. Well, after 15 well used years of 247 running, the board went out. So, instead of replacing the board I opted to replace the unit with another ADP. I don't think you can ask for many more trouble free years from any heater.