Boiler Installed Under Cabinet Apr 15, 2016

I had an 18'x20' addition to heat with Hydrondic floor heat, I looked at Micro Boilers for less money but the EMB-S-5, had many built in features which made it much more economical, and easier to install. It had to fit underneath a cabinet so the size of the unit was able to be installed where I needed it. With the thermostat relays and the pump start relay built in, it was very easy to install on my one zone system. The floor was warm over night, it is quiet, and is working perfectly.

Lg Wall Mounted 2-zone System - 30,000 Btu Outdoor - 9k + 18k Indoor - 19.2 Seer Review Apr 20, 2016

I just had my new system installed. It is a great system. It is very quiet and cools are home very well. One thing if you order a a/c system don't what to long because they run out.

Nice Unit, Fan Adjustment Instructions Are Vague Aug 13, 2016

Purchased this HRV to replace our 22-year old Mayaire unit. Didn't realize until the HRV arrived that it must hang for installation. My original unit sat on a table I built for it. So it took quite a while to find the right spot to have good access for straps, and not interfere with existing duct lines for old unit. The unit is much quieter than my original one, which is a plus. The only issue I had with the new unit is that the instructions for adjusting fan speeds are pretty vague. It took... more

Keep Turning It Down Dec 19, 2016

Just to say - it is great except can't seem to control the temp. I'll keep trying as have only had it two months. Always have hot water, but almost burn my hands sometime. Perhaps I must make larger adjustments -

Love Is Fantech Aug 15, 2016

I used this inline fan to hook up to my vent hood in my kitchen. Even though this product was assembled in America, the motor was made in Germany and you certainly can't go wrong with German technology. I also brought LD10 silencer to attach directly to the fan and placed the silencer between the vent hood and the fan. I also purchased the FC10 clamp to hold the silencer and fan in place. I find the clamp itself was not good enough to hold fan and the silencer. To give me a piece of mind,... more