Nice Panel Radiator Sep 12, 2016

I just wish it was more simple to figure out which connectors were needed. The description should be simpler. All I wanted was 1/2" copper connections but somehow the unit showed up with PEX connections. Overall good radiator though.

Modine Noisy May 10, 2016

After waiting 26 days to get my Effinity 93 110000 btu unit, I installed it only to find out the propeller fan was very noisy. It is louder than my air compressor. Modine will not honor the warranty unless you use a professional installer. If you are a do it yourselfer, don't buy this unit. The propeller motor is cheap and creates a lot of vibration noise. Even if the motor was replaced under warranty, it would still be the same noisy motor. If you want to be able to talk in the vicinity... more

Perfect Unit Oct 01, 2016

This unit replaced a older Mitsubishi unit that we replaced. The service from e comfort was perfect.

Really Nice Heater At A Great Price Sep 20, 2016

I actually bought 5 Pensotti Wall Panel Radiators, 3 of the 20" x 24" and two of these 20" X 48" units. They are replacing hot water baseboard heaters in a basement apartment. These heaters are stylish, extremely efficient and are priced very nicely. Installation was a snap using the included hardware, HOWEVER, I highly recommend purchasing an extra set of brackets for the 20" x 48" heater due to its weight. I used 3 brackets on each heater for a rock solid... more

Warmwire Heated Floor Jun 02, 2016

I installed a WarmWire heated floor in a 6'x8' coat room that had no other source of heat. It is on a concrete slab with 2 outside walls and a wall to an unheated attached garage. I glued 2 6mm thick sheets of Cerazorb synthetic cork directly on the concrete. It was super easy to lay the wire on top on the cork using the metal clip system provided. To be safe, I laid a sheet of 1/4" luan plywood on top of the wires while laying the tile. I checked the resistance in the wires at each step... more