Keep Turning It Down Dec 21, 2016

Just to say - it is great except can't seem to control the temp. I'll keep trying as have only had it two months. Always have hot water, but almost burn my hands sometime. Perhaps I must make larger adjustments -

Great Furnace Feb 24, 2016

It was an easy installation and it went in with no problems. Didn't have to do any adjustments all the factory setting were good and it went right in and hook up was seamless. I would buy another!

Well Made Heater Dec 14, 2016

This heater was easy to install, it is made of high quality metal. Nice to have power connections on both sides of the heater and ample amount of heat.

Great For Woodshops Sep 10, 2016

I have a 14 X 40 wood shop and was looking for something to heat/cool it that wouldn't cost a lot of money and also not run my electric bill through the roof. I think this unit is the answer. It was simple to install with no labor costs and it runs quiet and efficient. It keeps the shop comfortable with low humidity great for cast iron tables. We placed it about 5" off the floor on the lower end of the building away from busy working spots and also dust. The building has R23 insulation... more

Nice Choice Jan 10, 2016

The radiators went together very easily with the connections provided to the heating pex and there were no leaks. very easy to bleed. they provide much more heat than I was getting from my old wall convectors and seem to retain the heat a long time after the boiler is off. Not hard to hang either as long as you separate the hanger prongs in increments of 1/2 inch. Also, my wife was pleasantly surprised by the appearance